Ks0110 keyestudio EASY plug Hall Magnetic Sensor: Difference between revisions

From Keyestudio Wiki
Jump to navigation Jump to search
Line 49: Line 49:


http://www.keyestudio.com/keyestudio-easy-plug-hall-magnetic-sensor-module-for-arduino.html
http://www.keyestudio.com/keyestudio-easy-plug-hall-magnetic-sensor-module-for-arduino.html
[[category:Module]]
 
 
[[category:EASY Plug]]

Revision as of 10:44, 30 October 2018

EASY plug Hall Magnetic Sensor


thumb

Introduction

This is a Magnetic Induction Sensor. It senses the magnetic materials within a detection range up to 75px. The detection range and the strength of the magnetic field are proportional. The output is digital on/off. This sensor uses the SFE Reed Switch - Magnetic Field Sensor.
Note: this module needs to be used together with EASY plug control board.


Specification

  • Sensing magnetic materials
  • Detection range: up to 75px
  • Output: digital on/off
  • Detection range and magnetic field strength are proportional
  • Size: 42.3*20mm
  • Weight: 5g


Connection Diagram


thumb


Sample Code

int ledPin = 13;                // choose the pin for the LED
int inputPin = 11;               // Connect sensor to input pin 11
int val = 0;                    // variable for reading the pin status
void setup() {
 pinMode(ledPin, OUTPUT);      // declare LED as output
 pinMode(inputPin, INPUT);     // declare pushbutton as input
}
void loop(){
 val = digitalRead(inputPin);  // read input value
 if (val == HIGH) {            // check if the input is HIGH
   digitalWrite(ledPin, LOW);  // turn LED OFF
 } else {
   digitalWrite(ledPin, HIGH); // turn LED ON
 }
}

Resources

PDF

https://drive.google.com/open?id=100ur6ksO4Turkl6qHkmHb2atWy35kv7k

Buy from

Official Website

http://www.keyestudio.com/keyestudio-easy-plug-hall-magnetic-sensor-module-for-arduino.html