Ks0110 keyestudio EASY plug Hall Magnetic Sensor: Difference between revisions

From Keyestudio Wiki
Jump to navigation Jump to search
No edit summary
Line 48: Line 48:
==Extension Experiment==
==Extension Experiment==


<span style="color: brown>'''Adding 4-digit LED Display'''</span><br>
<span style="color: brown><big>'''Adding 4-digit LED Display'''</big></span><br>


'''Hookup Guide'''<br>
'''Hookup Guide'''<br>
Line 69: Line 69:


<br>
<br>
==Resources ==
==Resources ==
'''Download the Arduino Code and PDF:'''<br>
'''Download the Arduino Code and PDF:'''<br>

Revision as of 14:56, 6 May 2019

Keyestudio EASY plug Hall Magnetic Sensor


Introduction

The Hall sensor is based on Hall Effect. It can detect whether there is a magnetic object nearby or not. And it correctly tells you through digital output.
This sensor uses the SFE Reed Switch - Magnetic Field Sensor. It can sense the magnetic materials within a detection range up to 75px.
The detection range and the strength of magnetic field are proportional.
It is useful for non-contact/waterproof type switches, position sensors, rotary/shaft encoders.
Note: this sensor needs to be used together with EASY plug control board.


Features

  • Connector: Easy plug
  • Sensing magnetic materials
  • Detection range: up to 75px
  • Output: Digital ON/OFF
  • Detection range and magnetic field strength are proportional


Technical Details

  • Dimensions: 41mm*20mm*18mm
  • Weight: 4.4g


Connect It Up

Connect the EASY Plug Hall Magnetic sensor to control board using an RJ11 cable. Then connect the control board to your PC with a USB cable.
thumb


Upload the Code

Below is an example code. Open or drag below code to Mixly Blocks and upload.

thumb


What You Should See


thumb

When magnetic beads are approaching to the sensor, the LED will be turned on. Otherwise, the LED is off.
thumb


Little Knowledge:
If you want to change another way, that is, once magnetic field is detected by sensor, LED is turned off; if no detecting magnetic field, LED is on.
Just need to change the LED state ON or OFF in the code, shown below.

thumb


Extension Experiment

Adding 4-digit LED Display

Hookup Guide
Connect the EASY Plug hall sensor, 4-digit LED display and red LED module to control board using RJ11 cables.
thumb


Upload the Code
Below is an example code.
thumb

thumb


What You Should See
When magnetic beads are approaching to the sensor, the LED will be turned on. Otherwise, the LED is off.
How many times the magnet approaches to the sensor? You should be able to see the result showed on the 4-digit LED display or serial monitor.

thumb

thumb



Resources

Download the Arduino Code and PDF:
https://drive.google.com/open?id=1CGKYNqPJzNIyAJS-0c4HKeRlfSf__EIB

Download the Mixly Code and Datasheet:
https://drive.google.com/open?id=1CmaoHzxFEEsAhN_zUWGp0rBeymhSTROJ



Buy from