Ks0110 keyestudio EASY plug Hall Magnetic Sensor

From Keyestudio Wiki
Jump to navigation Jump to search
Keyestudio EASY plug Hall Magnetic Sensor


Introduction

The Hall sensor is based on Hall Effect. It can detect whether there is a magnetic object nearby or not. And it correctly tells you through digital output.
This sensor uses the SFE Reed Switch - Magnetic Field Sensor. It can sense the magnetic materials within a detection range up to 75px.
The detection range and the strength of magnetic field are proportional.
It is useful for non-contact/waterproof type switches, position sensors, rotary/shaft encoders.
Note: this sensor needs to be used together with EASY plug control board.


Features

  • Connector: Easy plug
  • Sensing magnetic materials
  • Detection range: up to 75px
  • Output: Digital ON/OFF
  • Detection range and magnetic field strength are proportional


Technical Details

  • Dimensions: 41mm*20mm*18mm
  • Weight: 4.4g


Connect It Up

Connect the EASY Plug Hall Magnetic sensor to control board using an RJ11 cable. Then connect the control board to your PC with a USB cable.
thumb


Upload the Code

Copy and paste below code to Arduino IDE and upload.

int ledPin = 13;// choose the pin for the LED
int inputPin = 9;// Connect sensor to input pin 9
int val = 0;// variable for reading the pin status
void setup() {
pinMode(ledPin, OUTPUT);// declare LED as output
pinMode(inputPin, INPUT);// declare push button as input
}
void loop(){
val = digitalRead(inputPin);// read input value
if (val == HIGH) { // check if the input is HIGH
digitalWrite(ledPin, LOW);// turn LED OFF
} else {
digitalWrite(ledPin, HIGH);// turn LED ON
}
}


What You Should See

When a magnet is approaching to the sensor, the LED will be turned on. Otherwise, the LED is off.
thumb


Resources

Download the PDF:
https://drive.google.com/open?id=100ur6ksO4Turkl6qHkmHb2atWy35kv7k

Download the Code:
https://drive.google.com/open?id=1U2Pd9XWUCM-kSSlZFRN8FwjgLWdFCx2z


Buy from