View source for Ks0117 keyestudio EASY plug Vibration Sensor Module

[[image:Ks0117-.png|thumb|600px|right|EASY plug Vibration Sensor Module ]]

==Introduction==
What's the simplest way to check vibration with Arduino? Well, use a vibration sensor from keyestudio. <br>
You can directly connect it to our EASY Plug control board with only one cable. Just vibrate this sensor, Arduino can receive a digital signal. It is easy to count and program in Arduino.<br>
It also comes with a potentiometer for you to adjust the sensitivity.<br>
In spite of simplicity, you can make full use of it with creative thinking, step counting, and crash warning light, etc.<br>
This module should be used together with EASY plug control board.<br>


<span style=color:red> '''Special Note:''' <br>
The sensor/module is equipped with the RJ11 6P6C interface, compatible with our keyestudio EASY plug Control Board with RJ11 6P6C interface. <br> If you have the control board of other brands, it is also equipped with the RJ11 6P6C interface but has different internal line sequence, can’t be used compatibly with our sensor/module. </span><br>
<br>

==Parameters==
* Sensor type: Digital
* Supply Voltage: 3.3V to 5V
* High quality connector
* Adjustable sensitivity via a potentiometer

<br>
==Technical Details==
* Dimensions: 46mm*16.7mm*17.6mm
* Weight: 6.2g
<br>

==Connect It Up==
Connect the EASY Plug vibration sensor to control board using an RJ11 cable. Then connect the control board to your PC with a USB cable.
<br>[[File:Ks0117-4.png|700px|frameless|thumb]]<br>

<br>
==Upload the Code==
Copy and paste below code to [http://wiki.keyestudio.com/index.php/How_to_Download_Arduino_IDE Arduino IDE] and upload.
<pre>
#define SensorLED 13
#define SensorINPUT 7  //Connect the sensor to digital Pin 7 which is Interrupt 1.
unsigned char state = 0;
void setup()
{
 pinMode(SensorLED, OUTPUT);
 pinMode(SensorINPUT, INPUT);
 attachInterrupt(1, blink, FALLING);// Trigger the blink function when the falling edge is detected
 }
void loop()
{  if(state!=0)
     {
       state = 0;
       digitalWrite(SensorLED,HIGH);
       delay(500);
     }  
     else
       digitalWrite(SensorLED,LOW);
}
void blink()//Interrupts function
{  state++;
}
</pre>

<br>

==What You Should See==
Done uploading the code, just vibrate the sensor, Arduino can receive a digital signal, and led will be turned on. If isn’t, you are able to adjust the sensitivity by a potentiometer.
<br>[[File:Ks0117-3.png|700px|frameless|thumb]]<br>

<br>

==Resources ==

https://fs.keyestudio.com/KS0117

<br>

==Buy from ==
*[https://www.keyestudio.com/new-keyestudio-rj11-easy-plug-vibration-sensor-module-for-arduino-steam-p0094-p0094.html  '''Official Website''' ]

*[https://www.aliexpress.com/store/product/New-Keyestudio-EASY-plug-Vibration-Sensor-module-for-Arduino/1452162_32643679818.html?spm=2114.12010612.8148356.28.14e424eaaJLgrn   Shop on aliexpress ]


[[category:EASY Plug]]