Ks0120 keyestudio EASY plug Infrared Obstacle Avoidance Sensor: Difference between revisions

From Keyestudio Wiki
Jump to navigation Jump to search
Line 60: Line 60:
<br>
<br>
==Resources ==
==Resources ==
'''PDF'''<br>
'''Download the PDF:'''<br>
https://drive.google.com/open?id=1CfudUxfXcDV7kbMPmSvEVgnUe9ERA3jw
https://drive.google.com/open?id=1CfudUxfXcDV7kbMPmSvEVgnUe9ERA3jw
'''Download the Code:'''<br>
https://drive.google.com/open?id=1jFtjRrplje9E0Z_lcI4pXkhq35rDihBn


<br>
<br>
==Buy from ==
==Buy from ==
'''Official Website'''<br>
'''Official Website'''<br>

Revision as of 15:07, 27 November 2018

EASY plug Obstacle Avoidance Sensor

Introduction

Infrared obstacle avoidance sensor is equipped with distance adjustment function and is especially designed for wheeled robots.
This sensor has strong adaptability to ambient light and is of high precision. It has a pair of infrared transmitting and receiving tube.
When infrared ray launched by the transmitting tube encounters an obstacle (its reflector), the infrared ray is reflected to the receiving tube, after a comparator circuit processing, the indicator will light up.
You can adjust the detection distance by rotating the potentiometer knob, the effective distance range of 2~40cm.
They can be widely used in robot obstacle avoidance, avoidance car, line count, and black and white line tracking and many other occasions.
Note: this module should be used together with EASY plug control board.


Specification

  • Working voltage: DC 3.3V-5V
  • Working current: ≥20mA
  • Working temperature: -10℃ to+50℃
  • Detection distance: 2~40cm
  • Output signal: TTL voltage
  • Effective Angle: 35°


Technical Details

  • Dimensions: 52mm*17mm*18mm
  • Weight: 6.2g


Connect It Up

Connect the EASY Plug obstacle detector sensor to control board using an RJ11 cable. Then connect the control board to your PC with a USB cable.
thumb


Upload the Code

Copy and paste below code to Arduino IDE and upload.

const int sensorPin=6;// the sensor pin
const int ledPin=13;// the LED pin
int sensorState=0;// variable for reading the sensor status
void setup(){
pinMode(ledPin,OUTPUT);
pinMode(sensorPin,INPUT);
}
void loop() {
// read the state of the sensor value:
sensorState=digitalRead(sensorPin);
// if it is, the sensorState is HIGH:
if(sensorState==HIGH){
digitalWrite(ledPin,HIGH);
}
else{
digitalWrite(ledPin,LOW);
}}


What You Should See

Done uploading the code, when the sensor detects an obstacle, the led is turned on.
thumb thumb


Resources

Download the PDF:
https://drive.google.com/open?id=1CfudUxfXcDV7kbMPmSvEVgnUe9ERA3jw

Download the Code:
https://drive.google.com/open?id=1jFtjRrplje9E0Z_lcI4pXkhq35rDihBn


Buy from

Official Website
http://www.keyestudio.com/keyestudio-easy-plug-infrared-obstacle-avoidance-sensor-module-for-arduino-starter.html