Ks0124 keyestudio EASY plug DS18B20 Temperature Sensor: Difference between revisions

From Keyestudio Wiki
Jump to navigation Jump to search
No edit summary
Line 78: Line 78:
==Resources ==
==Resources ==


'''Datasheet'''
'''PDF'''


http://www.keyestudio.com/files/index/download/id/1464232246/
https://drive.google.com/open?id=1thhRA_Qcgri0Z0hs8L2zu6FqEyOiLvi3


==Buy from ==
==Buy from ==

Revision as of 14:59, 15 November 2017

EASY plug DS18B20 Temperature Sensor


thumb

Introduction

This DS18B20 Temperature Sensor Module can be used to quantify environmental temperature testing. The temperature range is -55 ~ +125 ℃, inherent temperature resolution 0.5 ℃. It also support multi-point mesh networking.
Note: this module needs to be used together with EASY plug control board.


Specification

  • Interface: Easy plug
  • Supply Voltage: 3.3V to 5V
  • Temperature range: -55 °C ~ +125 °C
  • Interface: Digital
  • Size: 40*20mm
  • Weight: 5g


Connection Diagram


thumb


Sample Code

http://www.pjrc.com/teensy/arduino_libraries/OneWire.zip

#include <OneWire.h>
int DS18S20_Pin = 2; //DS18S20 Signal pin on digital pin 2
//Temperature chip i/o
OneWire ds(DS18S20_Pin);  // on digital pin 2
void setup(void) {
 Serial.begin(9600);
}
void loop(void) {
 float temperature = getTemp();
 Serial.println(temperature);
 
 delay(100); //to slow down the output so it is easier to read
 
}
float getTemp(){
 //returns the temperature from one DS18S20 in DEG Celsius
 byte data[12];
 byte addr[8];
 if ( !ds.search(addr)) {
     //no more sensors on chain, reset search
     ds.reset_search();
     return -1000;
 }
 if ( OneWire::crc8( addr, 7) != addr[7]) {
     Serial.println("CRC is not valid!");
     return -1000;
 }
 if ( addr[0] != 0x10 && addr[0] != 0x28) {
     Serial.print("Device is not recognized");
     return -1000;
 }
 ds.reset();
 ds.select(addr);
 ds.write(0x44,1); // start conversion, with parasite power on at the end
 byte present = ds.reset();
 ds.select(addr);    
 ds.write(0xBE); // Read Scratchpad
 
 for (int i = 0; i < 9; i++) { // we need 9 bytes
   data[i] = ds.read();
 }
 ds.reset_search();
 
 byte MSB = data[1];
 byte LSB = data[0];
 float tempRead = ((MSB << 8) | LSB); //using two's compliment
 float TemperatureSum = tempRead / 16;
 
 return TemperatureSum;
 
}

Resources

PDF

https://drive.google.com/open?id=1thhRA_Qcgri0Z0hs8L2zu6FqEyOiLvi3

Buy from

http://www.keyestudio.com/keyestudio-easy-plug-ds18b20-temperature-sensor-for-arduino.html