Ks0128 keyestudio EASY plug ADXL345 Three Axis Acceleration Module

From Keyestudio Wiki
Jump to navigation Jump to search
Keyestudio EASY plug ADXL345 Acceleration Module

Introduction

The ADXL345 module is a low power, 3-axis MEMS accelerometer with high resolution (13-bit) and measurement at up to ±16g (gravitational force).
Digital output data is formatted as 16-bit twos complement, and is accessible through either a SPI or I2C digital interface.
The ADXL345 is well suited to measures the static acceleration of gravity in tilt-sensing applications, as well as dynamic acceleration resulting from motion or shock.
This module needs to be used together with EASY plug control board.

Special Note:
The sensor/module is equiped with the RJ11 6P6C interface, compatible with our keyestudio EASY plug Control Board with RJ11 6P6C interface.
If you have the control board of other brands, it is also equiped with the RJ11 6P6C interface but have different internal line sequence, can not be used compatibly with our sensor/module.


Features

  • Connector: Easy plug
  • Working Voltage: 2.0-3.6V
  • Ultra Low Power @2.5v: 40uA /working mode; 0.1uA / standby mode
  • Communication interface: I2C / SPI
  • Tap/Double Tap Detection
  • Free-Fall Detection


Technical Details

  • Dimensions: 41mm*20mm*18mm
  • Weight: 4.6g


Connect It Up

Connect the EASY Plug ADXL345 Acceleration module to control board using an RJ11 cable. Then connect the control board to your PC with a USB cable.
thumb


Upload the Code

Below is an example code. Open or drag below code to Mixly Blocks and upload the code to your board to check the 3-axis acceleration data and the module's tilt information.

thumb


What You Should See

Open the Serial monitor to see the 3-axis acceleration data. See changes as you sway the Accelerometer.
thumb


Little Knowledge:
If you think the monitor’s result is too fast to see the data clearly, you can drag a Delay block to add into the source code. Shown below.
After that, upload the code again and open the monitor, you should be able to see the display data clearly.

thumb



Extension Experiment


Controlling Three LEDs

Hookup Guide
Connect the EASY Plug ADXL345 Acceleration module and three LED modules to control board using RJ11 cables.
thumb


Test Code
Upload the test code below to your board to check the 3-axis acceleration data and the module's tilt information.
thumb


What You Should See

thumb

Upload success, open the serial monitor, it prints out the value of X,Y,Z axis. Each axis controls a light. If the measured value is greater than 200, LED lights up.
thumb

thumb

thumb



Resources

Download the Arduino datasheet:
https://drive.google.com/open?id=1T8nejCErqCIU77e3dA2IvNUA_3VbsHq3

Download the Mixly Code and Datasheet:
https://drive.google.com/open?id=1Oqg067IBgaQSLoRQcvfxpAa6rR1i2HVs



Buy from