Ks0203 keyestudio Steam Sensor: Difference between revisions

From Keyestudio Wiki
Jump to navigation Jump to search
Line 20: Line 20:




Pin Definition:<br>
'''Pin Definition:''' <br>
S:Signal Output<br>
S:Signal Output<br>
+:Power Supply(VCC)<br>
+:Power Supply(VCC)<br>

Revision as of 11:48, 20 September 2017



Introduction

Steam sensor is an analog sensor and can be made as a simple rainwater detector and liquid level switch. When humidity on the face of this sensor rises, output voltage will increase.


thumb

Caution: connection parts is non-waterproof, so please don’t put them into water.

Performance Parameters

1.Working Voltage: 3.3V or 5V
2.Working Current: <20mA
3.Range of Working Temperature: -10℃~+70℃
4.Interface Type: Analog Signal Output
5.Size: 36mm x 20mm


Pin Definition:
S:Signal Output
+:Power Supply(VCC)
-:Ground(GND

Connection Diagram


thumb

Codes

void setup()
{
Serial.begin(9600); //open serial port, and set baud rate at 9600bps
}
void loop()
{
int val;
val=analogRead(0); //plug vapor sensor into analog port 0
Serial.print("Moisture is ");
Serial.println(val,DEC); //read analog value through serial port printed
delay(100);
}

Result

When you detect different degree of humidity, the sensor shows the current value. Shown as following picture, when the sensor detects steam rose from the hot water,the value is displayed on serial monitor.
thumb

Resources

Datasheet

http://www.keyestudio.com/files/index/download/id/1479182314/

Buy from

http://www.keyestudio.com/keyestudio-vapor-sensor.html