Ks0264 keyestudio Two-channel Solid State Relay Module

From Keyestudio Wiki
Revision as of 10:19, 8 January 2021 by Keyestudio (talk | contribs) (→‎Resource)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Keyestudio Two-channel Solid State Relay Module


thumb


Introduction

Keyestudio two-channel solid state relay is active at LOW level, that is to say, the input control signal is the low level (0-1.5 V), the relay is on; while the input control signal is high level (3-5 V), the relay is off.

Solid State Relay is a new kind of contactless switching device, which is composed of all solid state electronic components.

Compared with the electromagnetic relay, it has higher reliability, with the features of non-contact, long service life, fast speed and less outside interference.
The output control terminal of keyestudio solid-state relay must be connected to the circuit, can only be AC (Alternating Current) , so that the solid state relay can be disconnected normally.


thumb


Performance Parameters

  • Electrical parameters:
Voltage Static Current Working Current Trigger Voltage Trigger Current
Channel 1 DC 5V 0mA 12.5mA 0-1.5V 2mA
Channel 2 DC 5V 0mA 12.5mA 0-1.5V 2mA
  • Output port: AC 100V/2A


Connection Diagram


thumb


Sample Code

 int BASE = 3 ;  //The first relay I/O port
int NUM = 2;   //Total number of relay
void setup()
{
   for (int i = BASE; i < BASE + NUM; i ++) 
   {
     pinMode(i, OUTPUT);   //Set the digital I/O port to output
   }
}

void loop()
{
   for (int i = BASE; i < BASE + NUM; i ++) 
   {
     digitalWrite(i, LOW);    //Set the digital I/O port outputs to "low", that is, gradually open relay
     delay(200);        //delay
   }
   for (int i = BASE; i < BASE + NUM; i ++) 
   {
     digitalWrite(i, HIGH);    //Set the digital I/O port outputs to "high", that is, gradually close relay
     delay(200);        //delay
   }  
}


Result

Wiring as the above diagram, after powered-on, the two-channel solid state relay is first connected and then disconnected successively, repeating alternately.


Resource

  • Code:

https://fs.keyestudio.com/KS0264

  • VIDEO:

http://video.keyestudio.com/ks0264/


Buy from