TS2355 Duinotech Keyestudio 4-channel Relay Module

From Keyestudio Wiki
Revision as of 17:24, 21 December 2023 by Keyestudio (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search


Keyestudio 4-channel Relay Module.png


Introduction

keyestudio Relay Shield employs high quality relay with four channels input and output.

It can be connected to 250V/10A AC element or 24V/10A DC element to the maximum, therefore, it can be used to control lights, motors, etc.

The modularized design makes it easy to connect to Arduino expansion board.

The output state of the relay is shown by a LED for the convenience of actual application.

Specification

Control signal: TTL voltage

Active at HIGH level

Rated load:

  • 10A 250VAC
  • 10A 125VAC
  • 10A 30DC
  • 10A 28VDC


Rated Through-current: 10A(NO)  5A(NC)

Max Switching Voltage: 250VAC  30VDC

Contact actuation time: ﹤10ms

Definition of module pins:

  • i) Pin 1- Pin 4----Controlling end
  • ii) Power supply (DC12V)
  • iii) Ground (GND)



Connection Diagram


Keyestudio 4-channel Relay Module-connection diagram.png

Sample Code

int BASE = 2 ;  // I/O pin connected to the first relay
int NUM = 4;    //total number of all relays
void setup(){
  for (int i = BASE; i < BASE + NUM; i ++) {
    pinMode(i, OUTPUT);   //set digital I/O pin as output
  }
}
void loop() {
  for (int i = BASE; i < BASE + NUM; i ++) {
    digitalWrite(i, LOW);    //set digital I/O pin as ‘low’, i.e. turning off the relay gradually  
 delay(200);                 //delay
  }
  for (int i = BASE; i < BASE + NUM; i ++) {
    digitalWrite(i, HIGH);    // set digital I/O pin as ‘high’, i.e. turning on the relay gradually    
    delay(200);               //delay
  }  
}